Original Waveshare CC-Debugger Programmer

Bitte beachten Sie: Die meisten CC Debugger, die aktuell angeboten werden sind Fälschungen!

Aus diesem Grund haben wir uns dazu entschlossen nur original Texas Instrumens Chipsätze in Markenprodukten von Waveshare zu verwenden, um eine 100% Kompatibilität für ZigBee USB Module auch für zukünftige Anwendungen zu gewährleisten. 

Original CC-Debugger von Waveshare zur Programmierung von System-on-Chip (SoC) Devies von Texas Instruments.

The CC Debugger is primarily used for debugging and programming the flash on CCxxxx 8051-based System-on-Chip (SoC) devices from Texas Instruments. CC Debugger also supports CCxxxx RF transceivers. In addition, CC Debugger is used for configuring the CC85xx devices with PurePath Wireless Configurator.

Key Features

• Performance
  • Compatible with the original TI CC Debugger
  • Supported Operating Systems: Windows 2000, Windows xp sp2/sp3, Windows Vista 32bit, Windows 7 32bit
  • Target voltage: 1.2V～3.6V
  • Capable of powering the target board from the debugger
  • Operating temperature: 0℃～85℃
• Supported Software
  • IAR Embedded Workbench For C8051
  • SmartRF Flash Programmer
  • SmartRF Studio
  • SmartRF Packet Sniffer
  • PurePath Wireless Configurator
• Connects to PC
  • Computer connection via USB interface

Supported Devices

• Programming and debugging the following 8051-based system-on-chips from Texas Instruments:
  • CC1110, CC1111
  • CC2430, CC2431
  • CC2510, CC2511
  • CC2530, 29., CC2533
  • CC2540, CC2541
  • CC2543, CC2544, CC2545
• Controlling the following transceivers from SmartRF Studio:
  • CC1120, CC1121, CC1125, CC1175
  • CC1101, CC110L, CC113L, CC115L
  • CC2520
• Configuring the CC85xx devices with PurePath Wireless Configurator:
  • CC8520, CC8521
  • CC8530, CC8531

LED Status

• OFF: The debugger has no power or there is no valid firmware on the debugger.
• AMBER (BOTH LEDS ON): The debugger is powered, but there is no valid firmware.
• RED LED BLINKING: The Debugger is in Boot Recovery Mode.
• RED LED ON: No device detected. This might be due to old firmware on the CC Debugger, or a problem with the hardware connection (make sure the target board is properly powered and connected correctly).
• GREEN LED ON: The target device has been properly detected. It is possible to start programming/debugging.